AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable AC Installation Across Irving
If you’re pricing a new cooling system in Irving, you’re probably weighing a replacement you didn’t plan for against the long DFW summer ahead. A typical AC installation in Irving runs $3,500-$7,500, and the written estimate sets the final price. We handle the full job: load calculation, equipment, and the transition work that older Irving homes usually need. Call (855) 759-1429. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Irving Homeowners Call Carrollton AC Repair for AC Installation
Irving isn’t one housing market. It’s at least two, and they don’t install the same way. That’s the reason people here call us: we work on whatever is already in the home, and we don’t steer you toward a brand because a dealer arrangement pays better. Our technicians have up to experience, and they arrive already familiar with the equipment. If your existing system is a York, a Bryant, a Daikin, or an American Standard, we know it before we walk in.
We’re an HVAC-only company. Not plumbing on the side, not roofing between calls. Replacement, repair, and furnace work under one roof, so the same team that sizes your new condenser can tell you straight whether the aging furnace is worth keeping. That matters in Irving, where equipment often fails in pairs after a long cooling season.
Estimates are free, and pricing is set per job by the written estimate. We’re licensed and insured, and we work with your insurer when storm damage is part of the picture. If you want the honest repair-or-replace answer instead of a sales script, that’s the call.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
HVAC Installation in Irving
HVAC Installation in Irving means two different jobs depending on which side of the city you’re on, and any crew that treats them the same is guessing. In south Irving, the work is attic-based and tight: a load calculation, a static pressure test, and often custom plenum or transition fabrication to mate a modern air handler to ductwork that’s been in place for decades. In Las Colinas and the DFW Airport edge, it’s packaged rooftop units and concrete-wall mini-splits, with crane access and noise ordinances setting the schedule. A full central system install typically runs $3,500-$7,500 here, and the written estimate sets the final price.
Load Calculation Before Anything Else
Equipment gets sized to the house, not to the square footage on a listing. Older Irving construction with single-pane windows and attic ducts has different heat gain than a newer condo, and an oversized unit short-cycles, which costs you comfort and humidity control. We run the numbers before we recommend a tonnage.
Ductwork and Transition Work
Most south Irving replacements need some duct correction. Undersized returns are common, and a modern air handler won’t perform on a duct system built for a 1970s unit. We fabricate the transitions on site rather than forcing a fit.
Heat Pump Installation in Irving
Heat Pump Installation in Irving makes a lot of sense for this climate. North Texas runs above 100°F for weeks in July and August, and the shoulder seasons are short, so a heat pump spends most of its life in cooling mode where it’s efficient, then handles the mild winter without a separate furnace. For homeowners adding a system to a converted space or a home with no gas line, it’s often the cleaner answer. Installed cost typically falls in the $3,500-$7,500 range, and the written estimate sets the final price.
Matching the System to the House
Heat pumps need correct airflow to work, so the duct assessment matters as much as the equipment choice. We check return capacity and static pressure before recommending a model. If your ducts can’t support it, we’ll tell you what has to change first.
When a Mini-Split Fits Better
In Las Colinas high-rises and older homes with no duct chase, a ductless mini-split avoids tearing into walls and ceilings. Routing refrigerant lines through concrete requires core drilling and coordination with building management. Done right, it keeps balconies usable and stays inside the building’s noise rules.
Trusted Brands We Service in Irving
We’re factory-familiar with nine of the most-installed brands in the country, and that list includes York, Bryant, Daikin, and American Standard. We don’t stock parts on a truck or run a parts counter, so if a component isn’t on hand we source it and schedule the return – no “we only work on what we sell” runaround. What that means for an Irving homeowner is simple: whatever name is on your condenser, the technician already knows the platform, the common failure points, and the control board layout. Multi-brand familiarity is the whole point of calling us instead of a single-line dealer. Our AC installation team covers replacement and new installs across the city.
See the difference
Before
After
Before
After
Before
AfterCommon AC Installation Problems We See in Irving Homes
- Oversized tonnage without a load calculation. It’s the most common mistake in south Irving’s post-war tract homes. A unit sized by guesswork short-cycles, and in tight older construction that shows up as sticky humidity and uneven rooms rather than obvious breakdowns.
- Corroded or fin-damaged rooftop coils. Las Colinas rooftop condensers take DFW storm-season hail directly. Bent fins and slow refrigerant leaks show up as reduced performance long before the unit quits, which is why rooftop installs here need coil guards and a hail plan.
- Mini-split placement that breaks the rules. In high-rises, a condenser on the wrong balcony wall can violate noise ordinances or block access. We coordinate with building management on placement and routing before drilling anything.
- Condensers buried under canopy debris. South Irving’s mature pecan and oak trees drop leaves and limbs onto pad-mounted units in tight side yards. We position equipment with clearance in mind so airflow doesn’t degrade by mid-summer.
Pricing for AC Installation in Irving, TX
Air conditioning installation in Irving typically ranges from $3,500 to $7,500 for a standard central system, and the written estimate sets the final price. That spread reflects real differences: tonnage and efficiency tier, whether duct transitions or a new plenum are needed, line-set length, and access. A second-floor attic air handler in a 1960s ranch is a different job than a ground-level closet unit. Rooftop and concrete-work mini-split installs in Las Colinas carry their own labor for access and coordination. We give free estimates and put the price in writing before work starts, so there’s no surprise on the invoice. For comparison, an AC repair in Irving runs $150-$650 and a furnace repair $150-$700, which is exactly the math we’ll walk through with you if you’re deciding whether to repair or replace.
| Service | Typical Estimated Range |
|---|---|
| AC Installation | $3,500 – $7,500 |
We Also Serve Cities Near Irving
Irving sits in the middle of the Metroplex, and we cover the neighbors too. Homeowners in Carrollton, Dallas, Grand Prairie, and Lewisville get the same multi-brand installation work, same free estimates, same written pricing. If you’re just outside the Irving line, call and we’ll confirm coverage. We serve Irving and the surrounding cities with the same team.
Serving Irving, TX – Our Local Coverage Area
We serve Irving and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About AC Installation in Irving
A mini-split avoids running new ductwork through concrete and shared building structure, which central AC can’t do in most high-rises. In Las Colinas condos, ducted systems are usually a building-level system, so an individual unit adds cooling with ductless heads instead. We’ll assess your space and tell you which fits. Call (855) 759-1429 for a free estimate.
Permits and inspections add days, not months, but the exact timeline depends on the city and the scope of the job. Replacements typically move faster than new installs that involve electrical or structural work. We’ll tell you what your specific job requires during the estimate. Call (855) 759-1429 to get started.
The right size comes from a load calculation, not square footage alone, because those post-war homes have single-pane windows and attic ducts that change the heat gain. Older construction in this area often ends up needing less tonnage than people expect, and an oversized unit makes humidity worse. We run the numbers before recommending equipment. Call (855) 759-1429 for a free estimate.
Yes. Irving’s long cooling season and mild winters are a good match for heat pump operation, and the system handles both directions without a separate furnace. Proper sizing and duct airflow matter more than the brand. Call (855) 759-1429 and we’ll price the options.
We inspect the coil fins and refrigerant circuit first, because rooftop condensers take direct hail exposure and fin damage often shows as reduced efficiency before a visible leak. Repair is sometimes viable; replacement is sometimes the cheaper path over the unit’s life. We’ll give you the honest answer either way. Call (855) 759-1429 for a free estimate.
Ready for a straight answer on your system? Call (855) 759-1429 for a free estimate on AC installation in Irving. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We work on your brand, we price in writing, and we’ll tell you if repair makes more sense than replacement.
Written by the team at Carrollton AC Repair.